3D printing PLA with embedded 18g wire - woke up with the idea to try it, did a test and it worked well. : r/3Dprinting

Just created this little clock extruder visualizer for the new Printables contest and it turned out pretty cool. : r/prusa3d

PDF) Design and implementation of a low cost bio-printer modification, allowing for switching between plastic and gel extrusion

Suddenly bad stringing with PLA – Assembly and first prints troubleshooting – Prusa3D Forum

3D Printing First Layer Problems - 3D NEWB

ASA is giving me trouble on my MK4. Sometimes prints OK, but lately looks like this. Have tried drying the ASA. Prusa thought it could be the load cell due to resistance

3D Print Warping: Why It Causes and How to Prevent It - WayKen

3dpg/ 3d Printing General - 4ChanArchives : a 4Chan Archive of /diy/

Polymaker LW PLA Filament 1.75mm Bright Yellow, Pre-Foamed PLA 800g Lightweight 3D Filament - PolyLite LW-PLA for Printing RC Plane, 190-210 °C Printing Temp., High Rigidity

Troubleshooting Guide to 7 Common 3D Printing Problems, our solution.

What am I doing wrong? PLA to ABS : r/3Dprinting

What am I doing wrong? PLA to ABS : r/3Dprinting