Is this area indicating z-compression? - General Discussion - Formlabs Community Forum
I’ve just assumed so but never had it confirmed - is this light blue are indicating z-compression, that the resin will flow out there or what exactly does it mean?
D2L Discussion Setup (Faculty) : IT Solutions Center
s41205-023-00197-5, PDF, Young's Modulus
Glazing of 3D-Printed Silica to Reduce Surface Roughness and Permeability
Create a Discussion Forum
Frontiers FAS—A Fully Actuated Segment for Tendon-Driven Continuum Robots
Additive manufacturing for COVID-19: devices, materials, prospects, and challenges, MRS Communications
Preform really needs improvement - Support & Troubleshooting - Formlabs Community Forum
TCT Europe 30.6 by TCT Magazine - Issuu
The new perpetual 3D Printing Thread, Page 90
RepRap Magazine - Issue 1 by Gary Hodgson - Issuu